Ceiling Fan Remote Not Working Light

Check whether you have a faulty connection somewhere between the switch fan and circuit breaker.

Ceiling fan remote not working light.

Confirm the reverse switch is not in a neutral position. Follow the steps below to determine the cause. If the remote light up on the camera viewfinder it is working perfectly. A short or an overloaded circuit can cause the breaker to trip or turn off.

See the links below to go to the ceiling fan area for detailed photos and instructions. Yes the ceiling fan remote control module may be faulty. They need to be set the same way on both the fan and the remote. You can do this by pointing it towards the camera of your phone and then pressing and holding a button.

Within 30 seconds use a small screwdriver to press and hold the learn button on the remote for 3 seconds. In this case you will need to purchase a new remote and program it for the ceiling fan receiver. The fan will turn on and light if applicable will blink three times signaling a successful synchronization. Screw them into.

If you have an older ceiling fan the switch may be worn out. The solution is to press the fan high button and then light on on the remote control unit and then pull the pull chains until the light comes on and the fan runs on high. This can usually be done by checking the dip switches. Look inside of the light bulb socket to make sure there are no burn marks or charred spots.

Flip the switch several times to make sure it is the right. Make sure the switch isn t in between positions. The battery in the remote control needs replacing. The light bulbs in the fixture are burnt out.

If no light is visible then it is busted. In this case replace the reverse switch. If you see black or burned areas this may be a sign that your ceiling fan light kit has a wiring issue. If you are using a remote or.

Other conditions that may prevent a ceiling fan from working. Should it become necessary to re sync the remote turn off the main power then turn it back on. If things look good return light bulbs that are in working order into their sockets. One way to know for sure would be to remove the receiver module at the ceiling fan and wire it direct.

So if the pull chain is in the off position the remote control will not be able to get any power to the ceiling fan light or fan. If the ceiling fan and light works normally then the remote control module will need to be replaced. Check to see whether you have loose switch wiring. Check the reversing switch.